I need help with replacing Molding/trim
Moderator: bfadmin
I need help with replacing Molding/trim
I would like to replace the molding/trim not sure what to call it. On our 2013 coach, It’s the trim that seals the body panels/roof section. It starts at the lower portion of the side panel runs up over the top and to the lower panel on the the other side. I have looked for it online but don’t know what to call it and tried 6 Roblees RV they had no clue! Can anyone help? It’s about an 1” wide.
Re: I need help with replacing Molding/trim
Amazon has RecPro 1" wide trim,should work fine,I have used similar, sealed well wili cover the lap where the 2 panels meet ok. Probobly need to drill new holes. I always seal the old holes to be sure no leaks before putting down the new strip.Good luck, the weather should be in your favor soon...Art Krause
-
- Posts: 12
- Joined: Sun Oct 17, 2021 10:44 pm
Re: I need help with replacing Molding/trim
Art - Is there any trick to getting the new trim in place? I figure I should go through mine in the near future, but I dont exactly know what I'm getting into. Did you replace your screws with stainless and then some sort of sealant over the screw heads?
Re: I need help with replacing Molding/trim
Thanks for the info