Generator not powering coach

[bobccamper3]

Hello all. So, I did a stupid thing and I was hoping someone can point me in the right direction to fix it. I have a 2004 26' RSB with a 40G Generac quiet pack. In the stair well is a switch that says "Stop engine before switching off". Needless to say I switched it off with the engine running. (don't ask why because I have no excuse other than being an idot!) Now the generator runs, but doesn't do anything. I'm so mad because everything was working fine before. I think I blew the transfer switch, but I was wondering if maybe it's something simpler that I could fix. All the fuses seem to be ok. the inverter seems ok as far as I can tell. There is a reset there on the inveter that doesn't appear to be resetting, not sure. Everything works on shore power.
I'm in Mass and J & D Power in NH has 2-3 month backlog. TIA for any assistance

20231027_202454.jpg (124.35 KiB) Viewed 3394 times

20231027_202545-EDIT.jpg (118.44 KiB) Viewed 3394 times

[whemme]

Check these two circuit breakers discussed in the Technical Library section on this forum. Click on the following link to go directly to it: viewtopic.php?t=4375

[bobccamper3]

Thanks for the info Bill, both circuit breakers are on. And lucky me, there's no mystery reset under the sink, so I'm still in the same boat. I'm still thinking I blew the auto transfer, and that's out of my league. I wish it was something simple cause I'm having a hard time finding an RV generator repair place. Probably try the place in RI I saw mentioned.

[bobccamper3]

For anyone interested, I did take the rv to J D Power in NH. They took the Gen out and had it all winter.
Long story short, it was the voltage regulator. They cleaned the slip rings and gave it a good tune up.
Runs great. Still cost me a $1000, but cheaper than a new one.
Thanks, Bob C.

[NHtrax]

I purchased my 1999 24 RB from Northwood RV (NH)he had mentioned if J & D power was backed up to try Cumming sales and service in Concord nh
12-1 Integra drive 1-800-286-6467 I'm not ready to service my Onan 4000 emerald GEN yet but would love to hear any feedback from Cummings
Good luck!!
John Payne